發布時間：2014-11-25 19:33 已被瀏覽 95 次

氣動電磁閥的日常維護要點如下：

1，對消除氣動電磁閥內雜質清除定期，氣動電磁閥，檢查磨損嚴重的情況的所有部分，并根據實際情況，考慮更換或修理?yè)p壞的部件。

2，當要拆卸氣動電磁閥，一套完整的其他形式在電源和關閉連接，并注意過程中拆下電磁閥的安裝序列的每個部分。

3，氣動電磁閥故障的問題主要包括線圈和密封等易損部件，線圈燒壞由于過載，密封本身作為易損件，是由于自然的磨損和撕裂，長時間的作用下。

4，氣動電磁閥工作時的振動，如果經常發生，很容易造成損壞的電磁閥，氣動元件，所以電磁閥的維修，也應保證定期的氣動電磁閥部件的工作環境的穩定性

固定，如螺栓，等。

5，如果氣動電磁閥的工作環境是開放的可能導致氣動電磁閥和部分生銹使電磁閥不能正常工作。所以需要維護，以保持性能穩定運行。

6，條件允許的情況下，如果氣動電磁閥的工作是很重要的，這就需要一個專門的維修人員，確保電磁閥故障率低的工作穩定性。這樣才能使工作效率更高，維修費用低，使用壽命長。

 

Pneumatic solenoid valve daily maintenance main points are as follows:

 

1, on a regular basis to remove the clear internal impurities of pneumatic solenoid valve, pneumatic solenoid valve ａnd check all parts for wear serious condition, ａnd according to the actual situation to consider replacement or repair damaged parts.

 

2, when to remove the pneumatic solenoid valve, power ａnd close the connection before the other form a complete set, ａnd pay attention to in the process of remove the solenoid valve installation sequence of each parts.

 

3, pneumatic solenoid valve malfunction problems mainly include coil ａnd seals ａnd other vulnerable parts, coil is burn out due to overload, seal itself as wearing parts, are due to natural wear ａnd tear under long time work.

 

4, pneumatic solenoid valve at work, if vibration often happens, it＇s easy to cause electromagnetic valve pneumatic components of damage, so maintenance of electromagnetic valve, also should guarantee the stability of the working environment of pneumatic electromagnetic valve parts on a regular basis

 

Fixed, such as bolts, etc.

 

5, if pneumatic solenoid valve work environment is open is likely to lead to the pneumatic solenoid valve ａnd parts of rust make electromagnetic valve cannot work normally. So the need for maintenance, to keep stable operation performance.

 

6, under the condition of allowing, if the pneumatic solenoid valve work is important, which requires a special maintenance personnel, ensure the working stability of the solenoid valve ａnd low failure rate. In this way can we make it work more efficient, lower maintenance cost, long service life.
國內相關電磁閥產品：http://www.ansifm.com/diancifa/
國外相關進口電磁閥產品：http://www.ansifm.com/fring/solenoidvalve/

    【聲明】： 以上文章或資料除注明為上海前澤閥門有限公司自創或編輯整理外，均為各方收集或網友推薦所得。其中摘錄的內容以共享、研究為目的，不存在任何商業考慮。
    目前網站上有些文章未注明作者或出處，甚至標注錯誤，此類情況出現并非不尊重作者及出處網站，而是因?yàn)橛行┵Y料來源的不規范。如果有了解作者或出處的原作者或網友，請告知，本網站將立即更正注明，并向作者道歉。