modbus rtu 轉EIB

集成網關intesisbox把Modbus 從設備轉成KNX控制系統，集成到Modbus RTU從站設備（冷水機組，樓宇，電表，暖氣地板，熱泵，PLC）到KNX控制系統轉換

IntesisBox acts as a Modbus RTU ｍaster device in its Modbus interface, reading/writing points of the Modbus slave device（s）, ａnd offering this point"s values through its KNX interface. IntesisBox acts in the KNX side as one more device of the KNX system. IntesisBox"s KNX EIB interface connects directly to the EIB bus ａnd is opto-isolated from the rest of the internal electronics
The Modbus interface of IntesisBox reads continuously by polling the Modbus slave devices/registers configured. If a non response of the Modbus slave is detected, the corresponding virtual signal inside IntesisBox will be activated indicating communication error with the device. All the updated readings of the Modbus registers are maintained in IntesisBox memory for immediate interaction with KNX when needed.
Each Modbus register of the slave device is associated to a KNX group address. All the Modbus registers of the different slaves are accessible through KNX group addresses.
When a change in any Modbus register/slave occurs, a write telegram is sent to the KNX bus, to the associated KNX group address. This is configurable individually per point.
IntesisBox KNX series are configured using LinkBoxEIB, a software tool for windowsTM which is supplied along with the purchase of IntesisBox with no additional cost. With the standard installation of LinkBoxEIB, a Demo project for integration of Modbus slave devices is also installed, using this demo project makes the engineering needed for this integration easy ａnd quick.

Intesisbox有三個版本－－-KNX MOdbus RTU主設備有不同的能力對每個型號

 Version with capacity of 100 points ａnd up to 254 slave devices. Ref. IBOX-KNX-MBRTU-100.
 Version with capacity of 500 points ａnd up to 254 slave devices. Ref. IBOX-KNX-MBRTU-A.
 Version with capacity of 3000 points ａnd up to 254 slave devices. Ref. IBOX-KNX-MBRTU-B.