一、產品介紹：
（一）、功能介紹：
1、 頻率范圍：740~790MHz；
2、 通道數量：2個；
3、 頻道數量：200個，手持頻道通用；
4、 疊機3臺，抗干擾能力強。
5、 PLL鎖相環技術：頻率穩定度∠±100Hz；
6、 發射功率高和低切換；
7、 發射操作鎖定功能；
8、 紅外線自動對頻；
9、 多重噪聲靜噪自動控制；
10、 兩通道Line混合輸出，XRL獨立輸出；
11、 發射LCD顯示頻道和電池電量；
12、 發射電池低壓閃爍至1.6V自動關機；
13、 接收各通道LCD分別顯示：頻率頻道、射頻強度、靜音、天線內部分極、及菜單內各指標調節內容；
14、 接收機手動音量調節；
15、 系統使用環境：溫度-20℃~+45℃，相對濕度85%；
16、 工作距離：野外1500~2000米；
（二）、產品電子技術指標介紹：
1、發射機工作頻率范圍：740MHz~790MHz；
2、發射射頻功率：≤80mW；
3、射頻調制噪聲：＜-65dBc；
4、射頻調制度：≤±75KHz；
5、系統接收靈敏度：-65~-105dBm可調；
6、系統音頻頻率響應：30Hz~18KHz ±3db；
7、輸入信號強度凈空比：＞15db；
8、信噪比：∠-85db；
9、失真度：≤1%；
10、輸出信號幅度：LINE160mV，XLR12mV；（400Hz/20KHz）。
11、音頻隔離度：＞60db；
12、發射機工作電壓：3VDC；
13、發射機工作電流：450mAmin（5#AA1000MHA電池連續工作2小時）；
14、接收機電源：12VDC/1000mADC；
（三）、產品包裝規格：
1、接收機外型：標準1U；
2、整機外包裝規格：530*330*130mm；
二、產品功能及操作方法：
（一）接收機操作：
- 頻道選擇：按上（或下）鍵選擇頻道（或頻率），按中鍵確認；
- 紅外線對頻：按中鍵進入菜單第二項（PRG IR），按上（或下）鍵發射紅外線進行對頻，紅外線對頻距離在1米以內進行。對頻時接收到當前頻點的射頻信號，自動中止對頻，或15秒后自動中止對頻；
- 靈敏度設置：按中鍵進入菜單第三項（SQELCH），按上（或下）鍵進入接收機的靈敏度設置，在強干擾和短距離使用時可將靈敏度在0dB到負45dB范圍內手動調節設置，按中鍵確認。
- 頻率和頻道顯示的切換：按中鍵進入菜單第四項（DISPL），按上（或下）鍵進行切換，CHANNL顯示頻道，FREQ顯示頻率。按中鍵確認；
- 音量調節：接收機背面手動調節音量；
- 通道鎖定操作：按中鍵進入菜單第5項，按上（或下）鍵，OFF解除鎖定，ON鎖定，防止使用中誤操作，按中鍵確認。
- 按中鍵菜單返回。
（二）手持麥克風操作：
1、麥克風射頻功率切換開關，H到L衰減7dbm左右,適用遠近使用距離切換，KTV置L位置使用，H是遠距離場合使用。
- 手持功能鎖定，開關由OFF到ON鎖定手持操作，防止使用中誤操作。
3、紅外線對頻時對正接收機的紅外線發射窗口1米以內進行。
（三）腰包麥克風操作：
1、腰包麥克風有三個應用：一是將功能轉換開關置于上位置時（吉它開關在左位置）使用頭戴，二是將功能轉換開關置于中位置時（吉它開關在左位置）使用領夾；將功能轉換開關置于下位置（吉它開關在右位置）時使用吉它；
2、紅外線對頻時對正接收機的紅外線發射窗口1米以內進行。
三、產品配置：
1、手持發射2只；
2、接收機一臺；
3、室內天線2根；室外天線一副；
4、產品介紹及使用說明書1份；
5、LINE對接線一條；
6、110~220VAC/12VDC/1ADC開關電源一只；
7、重量：整機4000克，手持420克。
8、1件5臺。
Product introduction:
(a), the function is introduced:
1, the frequency range: 740 ~ 790 MHZ;
2, the number of channels: 2;
3, the number of channels: 200, channel with gm;
4, folding machine 3 units, strong anti-jamming capability.
5, PLL phase-locked loop technology: frequency stability < + 100 hz;
6, high transmission power ａnd low switching;
7, launch locking operation;
8, infrared automatic frequency;
9, multiple noise noise automatic control;
10, two Line hybrid output, the XRL outputs independently;
11, launch channel LCD display ａnd battery;
12, launch battery low voltage flicker automatically shut down to 1.6 V;
13, receive the channel respectively display: LCD frequency channel, the strength of rf, mute, antenna inside part, ａnd the menu in adjusting the content of each index;
14, a receiver manual volume;
15, the system using the environment temperature - 20 ℃ ~ + 45 ℃, relative humidity 85%;
16, working distance: field of 1500 ~ 2000 meters;
(2), electronic product technical indexes are introduced:
1, transmitter range of working frequency: 740 MHZ to 790 MHZ;
2, launch rf power: 80 mw or less;
3, rf modulation noise: < - 65 DBC;
4, rf modulation: + 75 KHZ or less;
Receiver sensitivity ａnd system: 5-65 - - 65 DBM is adjustable;
6, the system audio frequency response: 30 hz ~ 18 KHZ plus or minus 3 db;
7, the intensity of the input signal is clear than: > 15 db;
8, the signal-to-noise ratio: < - 85 db;
9, distortion degree: 1% or less;
10, output signal amplitude: LINE160mV XLR12mV; (400 hz / 20 KHZ).
11, audio isolation: > 60 db;
12, transmitter working voltage: 3 VDC;
13, current transmitter: 450 mamin (5 # AA1000MHA batteries work continuously 2 hours);
14, a receiver power supply: 12 VDC / 1000 madc;
(3), product packaging specifications:
1, the receiver appearance: standard 1 u;
2, the machine packing specification: 530 * 330 * 130 mm;
Second, the product function ａnd operation method:
(a) a receiver operation:
1, channel selection, press the up (or down) button to ｓelect the channel (or frequency), press the button to confirm;
2, infrared frequency, press the menu button to enter in the second (.prg IR), according to launch infrared (or down) button on the frequency of infrared for frequency range within 1 meter. Receives the current frequency point at the time of the frequency, radio frequency signals, automatic suspension of frequency, or after 15 seconds automatically suspend the frequency;
3, sensitivity setting: press the third button to enter in the menu (SQELCH), according to (or below) on the key into the receiver sensitivity setting, when used in strong interference ａnd short distance sensitivity can be within the scope of 0 db to minus 45 db manually adjust the Settings, press the button to confirm.
4, frequency ａnd channel display switch: press the button to enter the menu item 4 (DISPL), according to (or below) on the key switch, the CHANNL display channel, FREQ display frequency. According to the key confirmed;
5, volume: receiver on the back of the manual to adjust the volume;
6, channel lock operation: press the button to enter the menu item 5, press (or) ON, OFF unlocked, ON the lock, prevent wrong operation in use, press the button to confirm.
7, back press button in the menu.
(2) handheld microphone operation:
1, microphone radio frequency power switch, attenuation, about 7 DBM H to L switch used far ａnd near distance, KTV L use, H is the distance.
2, holding the lock function, switch from OFF to ON lock hold operation, to prevent the use of wrong operation.
3, infrared to align the receiver at the time of the frequency, infrared launch window within 1 meter.
(3) the pocket microphone operation:
1, purse the microphone has three applications: one is the function switch in the on position when the switch is in the left position (guitar) using a head, 2 it is puts function switch in position using LingGa switch in the left position (guitar); Switch will function switch in the location (guitar) in the right position to use when the guitar;
2, infrared to align the receiver at the time of the frequency, infrared launch window within 1 meter.
Three, product configuration:
1, 2 only holding a launch;
2, a receiver;
3, indoor antenna 2 root; Outdoor antenna is a vice;
1 4, product introduction ａnd operating instructions;
5, the LINE of wiring a;
6, 110 ~ 220 vac/adc 12 VDC / 1, a switch power supply;
7, weight: 4000 g machine, hand-held 420 grams.
8, 1 piece of 5 units.
